Search results

I have two batteries and fuel pump in the center rear compartment. Show me where your batter Switch is mounted Also will take wiring tips. Example should I also ass the motor starting to the cutoff switch? I mainly want it for the accessories etc.(something seems to slowly drain the battery...

My bow panel is starting to come apart. Anyone know where I can find a replacement?

I am about to install my ULTERRA and Purchased the MKA 51. Not Sure how I am going to install it. Looks like it may be difficult.

I purchased a Hydraulic seat pedestal from BP but it is sort of loose in the hole. It can be moved side to side with just a tiny bit of play. Not snug at all. Any ideas? Its a screw-in pedestal. No threads ever connect and theres slack in it. 2000 XB2003 This is the unit I purchased...

I don't really tournament fish naymore. Casual fish in current on a Delta. Mobile Delta Causeway. Alabama river. Any complaint's with the newer model? Does it handle running into stumps and limbs ok? How do you have it mounted? What size shaft? Thanks.

Any tricks on installing under the front deck? What adhesive works best? Spray adhesive would work since it has zero traffic etc?

My DI is mounted in the back if the boat. I need one for the tray just for depth while cruising. Want the Y adapter allow both to run at the same time? XB2003 Helix 7 Di

I was trying to mount my transducer where the old medallion pito tube was and had two screws break off in predrilled holes. I've never seen this before. This should be fun. Wth? Any idea or tips on getting the old screws out?

Could you post a pic of where you mounted the hardware for the poles/support and what width you purchased that for correctly? Thanks.

Has anyone mounted where the speedo pitot tube was originally installed? My transducer is too large to mount in the tray and plus it's D.I.

SSIA THE ONE THWT FITS IN THE SPEEDO HOLE. Thank.

I purchased a Helix 7 with DI(no side image) would it work in the transducer tray(xb2003)? I need it to work while on a plan at lower cruising speeds(I run and fish in shallow water areas) So the backplate option is off the table. Thanks

Any pics of gloveboxes where the radio goes? I'm going with the round radio the size of a flasher instead. Would love more storage for wallets, keys, phones etc.

I have detwiler hydrauilc plate. Is it possible to mount a skid planer?

Anyone making these or still available at factory? Also, Im missing the small Allison stickers that are toward the rear(both sides of the boat) is that a sticker or plaque?

Looking to tie in to some power. Couldnt find a distribution block under the dash to tie in some electronics.

Which motor would be best and what differences would I see between the two? Will the 280 give me a huge amount of power? Money isn't the issue (long story) I have both motors and the 280 is fresh with only 150ish hours and never been ran WOT at all.

I've seen a few random listings that listed a cooler on a xb2003. Can't find any pics or info this was offered. Any ideas? Price? Details where it goes.

Located in South Alabama