Search results

In-Control foot throttle that has been sitting on the shelf for many years is finally getting installed. After looking it over I see I'm missing the adjuster that uses a jam nut to takes the final slack out of my cable. It's a 5/16" threaded on one end and accepts the cable housing on the other...

I'm looking to speed up the trim on my 280 OS. What trim pump works the best for this without going to a 24 volt since this is just for lake use. Brand and model# would be very helpful?

I want to put a V-4 on a ultra lite Allison. How much dependable HP is possible out of a V-4? It needs to be dependable for long runs. What RPMs will they run, and what gears are available?

So as not to hijack the other thread we should discuss Berryessa in a different place. Lou, that is a real shame. I guess we can all sit on the fence and watch it all happen. I guess I could understand them cancelling the leases on the mobils that had been there for many benefiting a small...

Does anyone have a manual to lookup the setting for the TPI on a 300 PM.

280 15" motor only has 21 total hours on it. Still on the boat if you happen to live in Calif. Not a scratch on this motor $11,500.00. I also have a used 280 SS that I would sell for $7500.00. I would like to sell one or the other not both. The second motor has 250 total hours and was freshen up...

Classes for Prop Testing 1. All 20 ft. or less boats with up to 225 hp 2. All 20 ft or less boats with 240 to 300 hp. 3. All 21 or larger boats with 225 to 300 hp. 4. Modified class is everything that doesn't fit above no limits There may need to be some fine tuning done to these...

Do they stamp something on a labbed Merc prop that shows it's been lapped. If so what do I look for on a labbed cleaver?

3 litre starting problem I have a 300 PM that was giving me a starting problem at the end of last year so I decided that I would look at it over the winter. Since the battery was 5 years old I changed it out for a new one with the same cranking amps. That did not fix the problem. I them went...

Do they have anything programmed into the ECU during breakin. I don't see anything in the manual. I love the motor it runs great. The prop is clean so I don't think it's double oiling.

I was back on the water today after making a lot of changes to my setup. I am getting real close in my opinion to the right setup for this rig. Still not happy with the holeshot with the 26 Trophy. They just don't ventilate enough the first second and a half. Anybody know how to fix that? Other...

I haven't seen anybody mention the article in the May 2005 issue of Family & Performance Boating. There's five full pages on the history of Allison's. It's a real good read if you haven't already seen it. Wish I new how to scan and post it. I think every Allison owner would enjoy reading it...