Recent content by tekajo

I am not sure if there is something simply to look for. My dash , running, anchor and accessory lights no longer work. Motor, trim , starter is just fine. I checked the fuses on the dashboard and they are OK. Any suggestions where to start looking for the problem?

24 pitch trophy. 2003 xb 225 promax with 12 inch setback. Pulls me up on slalom at 170 lbs with no problem. Not like a tournament boat but no struggle. I sometimes use a 26 pitch trophy but I am 49 years old and not as easy to hang on as ten years ago. Still like naked women.

how deep are the scratches?

Thanks, But I am using a 12 volt setup

I have an allison 2003 and use the boat for fishing probably less than 50 percent of the time. I need a new trolling motor and the simple design of a hand control bow mount appeals to me. They are usually sold as a longer shaft than what I would need in a foot control. Does anyone have any...

Does anybody know how much better fuel economy with the new Brucato ACU?

Thanks, I also have a 2003xb with 225 promax. 24 pitch trophy sounds good.

I currently use a 26 pitch trophy for all around use including water skiing. It is somewhat of a struggle to start slalom. I do not need arm wrenching power but need a little more hole shot? What is a good pitch to use?

Thanks John, Simple but works.

The sportmaster lower unit I have already has four holes drilled. The previous owner must have had some type of hydrofoil. My question is how does the Allison hydrofoil come? Are holes pre drilled? How is it mounted? Machine screws with bolts on top?

Go to http://www.bassboatcentral.com/index.htm It will be advertised on the home page. Lots of threads on the forum about product. Quite a few bassboat fisherman just love the product.

I used the magic eraser on the inside with good result. Not a whole lot of scrubbing needed. Are you worried it might scratch the fiberglass? After cleaning I use rag with some bass boat saver and it looks great.

Use magic eraser for the inside. Looks like a sponge with water. Works very well.

Thanks, This spring will be my third season with the boat and I have never changed props

I currently have a 26 pitch trophy with fat shaft on my 2003xb. I have jjust purchased a 27 srx that is hubbed for a fat shaft. Will I need different washers or nut than is used with the trophy?