Hanzt
Probationary User
Hey Ya'll-I will call Bill at the factory tomorrow but would like some insight too. Alli SS has helped hand forwarded me to Bill.
I receintly became and Alli Owner and am putting a new Lowrance 332C in it with a shoot thru the hull transducer. Again Alli SS was helpfull in finding the tray to place the unit in, unfortunately there was an old one there. I have not attempted to "tap" it out yet. It is set in about a 1/4" of epoxy.
My plan was to try and chip away at one side until at the edge of the transducer and try to pop it up.
Any suggestions would be great.
Tim
I receintly became and Alli Owner and am putting a new Lowrance 332C in it with a shoot thru the hull transducer. Again Alli SS was helpfull in finding the tray to place the unit in, unfortunately there was an old one there. I have not attempted to "tap" it out yet. It is set in about a 1/4" of epoxy.
My plan was to try and chip away at one side until at the edge of the transducer and try to pop it up.
Any suggestions would be great.
Tim