Question about Smartcraft system

Kruton

Kruton

Active Member
Joined
Mar 19, 2005
Messages
141
Points
18
Location
Watts Bar.
Im planning on buying the smartcraft system moniter gauge from Livorsi. Its showing that you can buy a wireing harness with or without a resistor? Which one do I need? Also should the 15ft harness be the length I need? Thanks
 
J

jimmyb

Active Member
Joined
Mar 15, 2005
Messages
703
Points
16
what motor and what boat model and where are you locating the gauge and how are you routing the cable? honestly, the 15' might be a bit short...

i will have to check on the resistor deal... i forgot how it went
 
XSive

XSive

Active Member
Joined
Mar 16, 2005
Messages
473
Points
16
Location
Canada
Resistor

It is my understanding, that you need to end up with a resistor at each end of the cable. It depends on what you want to do. SmartTach and Link guages. etc. The link below may help. You can get the cables with resistors at each end or use the termination blocks with added resistors.

If all your using is the system monitor you probably only need the cable with resistors at each end. I'd call Livorsi and ask. They have great customer service.

Probably didn't clear anything up, sorry.


http://www.mercurymarine.com/united_states
 
You must log in or register to reply here.
Top