Mercury 3.3L Stroker motor

[Todd D]

Custom built 3.3L Mercury Stroker motor. It sits on a 2005 20" 300x offshore midsection. The powerhead is identical to the one that Hydrilla sold. It has the down draft intake and the 300x style electronics that Eric Simon did the Motorola ecu on. It still has the factory oil injection but it can be removed by Simon if you'd like. Motor is just over 150lbs of compression on every cylinder. Motor has probably around 20 hrs but I will verify with the DDT. The motor also has the Simon popit diverter and Hydro Tech tuner.
Entire motor with 1.62 gearcase $22,500
without the gearcase $20,000
would also be willing to short shaft(15") $25,000

For more specific internal detail give me a call (239)293-4731

 

[Todd D]

This motor is strong for sure, loads of torque!!!! This motor is almost identical to the motor on the White Knuckles Stroker, the only difference is a little bit more has been done in the block on this one. I have three other motors out there with the same porting as this one and one has almost 100 trouble free hours. The white knuckles boat has been 121.46 so far. This motor is very similar to the Simon 3.3L stroker motors with a little more porting and the factory oil injection.


http://www.youtube.com/watch?v...st=UL

http://www.youtube.com/watch?v=CqVgbNFk3nk

 

[Todd D]

Price reduced $15,000 no gearcase. If you want to take a ride and feel the incredible torque the motor is currently rigged on a LCB (Lanier Custom Boat)