Westy
Active Member
I just bought these to replace the plastic battery trays that came from Allison.http://www.artecwelding.com/product_info.php?cPath=30&products_id=83&osCsid=3d209dcaa03160195499a3ac2d7c75a5
My question is what is the safe depth you can sink a screw into the battery compartment area? I'm thinking about putting epoxy on the bottom of the trays before I screw them in. Any thoughts there? I figure you can pop a transducer off that's been epoxied so I should be able to remove the trays if I ever had to.:cool
Westy
My question is what is the safe depth you can sink a screw into the battery compartment area? I'm thinking about putting epoxy on the bottom of the trays before I screw them in. Any thoughts there? I figure you can pop a transducer off that's been epoxied so I should be able to remove the trays if I ever had to.:cool
Westy