Recent content by Todd D

Very cool. He's going to be posting pics of that exact build/modification on my S&f for sale add on the miscellaneous parts section!

Thanks for posting the pic Dave! If you have a single ram you can buy the 280 ros or 200xs ros swivel bracket and steering arm and bolt everything else from your 3L to it. Or you can have you 20" clamp shortened. If you have your 20" shortened the ram has to be shortened also. Otherwise...

Offshore racing tested and approved in the rough water at Cocoa Beach, Marathon, The Lake race and Sarasota!

Brand new $1,500 These are the 300PM and 300X style mid. They will work on any 3L/3.2L efi or opti with any cowl with a little knowledge and a few modifications. let me know if you have any questions.

Here's a 15" 3L mid http://www.bbcboards.net/motor-parts/624999-15-mercury-3l-midsection.html

Sold Thanks

Sold Thanks

Sold Thanks

The gen ones come on a 2 piece plate and run the poppet. The gen 2's do not use the poppet. The gen ones pull water to cool the compressor off the exhaust plate. The gen 2's cool off the top of the block.

For sale is a 33p hydromotive 4 blade with the big barrel. Prop is flo torque hub system. Blades have been profiled, balanced, blueprinted and the barrel has been trimmed. Dual (8) PVS holes. $650

30p hydromotive 4 blade big barrel. This prop is hubbed for a fat shaft 19 spline prop shaft. 1" vent holes. Blades have been profiled, balanced, blueprinted and the barrel has been trimmed. $650

29p hydromotive 4 blade big barrel. This prop is hubbed for a fat shaft 19 spline prop shaft. 1" vent holes. Blades have been profiled, balanced, blueprinted and the barrel has been trimmed. $650

Yes, both of these will fit any 3L sportmaster on any EFI/DFI/optimax/pro xs/ xs/ 3.2L 300xs stroker. The drive shaft 4 seal housing will also fit Gen 1 torquemasters!

These were made so you can snap them into the factory old style harness mount!

I'll post a few more tomorrow.