Recent content by goin insane

Late Model V6 Merc 2.0 150hp, Lots of Porting, Standard Bore, No sleves, Horizontal front half. Bare block and front half only. Work done by REMCO in Lake City, FL $500.00? OBO I will email pics if interested

The holeshot is pretty good, Im with yall about 10" being to much but it was an allison jackplate I had so I used it. The boat pourposes until it gets around 35mph. If any one has a 15" midsection for sale let me know, I need one. I guesed that the motor was about 3/4" but I measured it today...

I have a 1974 16' allison, I would like some advice on how to set this boat up, The motor is a 150 merc with a bob's nose cone stock lower unit, 14x23 allison cut chopper, 10" set back 3/4" below the pad. Steering is in the center along with the batt. fuel tank and trim pump just behind the...