Recent content by 300R Ally 2+2

That may be the same as mine and may be a big help. Thank you!

I'll send you my cell number. Thank you very much!

Does anyone have a wiring diagram for a 2008 XB21 2+2? I could also use some pics from above and below the switch panels at the terminals behind the switches. I've found some wires disconnected and am having issues figuring out where they go. Thanks!

SOLD Headed to Louisiana

$17,500

I'm selling my 2000 XB2003T, 1998 Merc 2.5L off shore 20"mid, 2004 280 powerhead, Stainless Marine trim indicator, Allison skid planer, 2019 Motorguide Xi3 trolling motor, power pole with tilt mount to allow it to lay flat on the deck when running or on trailer with hydraulic quick disconnects...

Thanks Dave. The boat is with Tim Powell @ Fastbass in Kentucky getting rigged and then headed to North Texas. Thank you sir!

Found and bought my next ride 2+2 this week.....Thanks Want to buy an XB21 2+2 w/o power. I have a new motor on order. Thanks

Want to buy an XB21 2+2 w/o power. I have a new motor on order.

thanks for the help on the setback. Did you have to add buoyancy to the inside of the jackplate to keep the stern up? I have a battery in the far back of each wing and am thinking of moving them up.

I'm going to sell it unless I find a 2+2 then I may sell the boat and motor. At this time I have the motor on order.

Thanks, I'll check that out!

Thank you for the info! You have that rig dialed in for sure. I use mine occasionally for fishing so I'm planning to move the batteries that are on the rear port/starboard wings up in the compartments to help lighten the back to offset the added weight of the 300R. Do you use any buoyancy in...

110....that's flying! Do you have a 3.0L on your rig? how does it sit?

What setback is being used on the big motors?